allendale

[dark_el_diablo]

wow i see but even though crystalcpuid says its allendale i have done a lil research and found about this

Allendale
For a very long time, it was considered that stripped down versions of the Conroe processors were code-named Allendale. In actuality, Allendale is a code-name for a different processor. Many suggest that E6300 and E6400 are actually code-named Allendale, however, the E6300 (1.86 GHz) and E6400 (2.13 GHz) processors are not code-named Allendale because they physically have 4 MB cache, same as their big brothers E6600 and E6700 - it is just that half of their physical memory is disabled. Traditionally, CPUs of the same family with less cache simply have the unavailable cache disabled (this allows parts that fail quality control to be sold at a lower rating). The fact that E6300 and E6400 are not code-named Allendale and actually code-named Conroe has been confirmed by Intel themselves.


hey dude thanks for letting me know... so now the big question is there a way to enable the other half? 8O


anywayz back to my o'cing..

my pc is not letting me o'c over 3.20 Ghz it is rock stable as it is these are the settings.
------------------------------
CHIPSET SETTINGS
----------------------------
Dram ecc mode = DISABLED
Hyperpath 3 = DISABLED
dram thresold = DISABLED
conf ram by spd = ENABLED
--------------------------------
CPU CONFIGURATION
--------------------------------
Mod ratio supp = DISABLED
Microcode Updation = ENABLED
Mac CPUID Val limt= DISABLED
Execute Disabled Funct = DISABLED
eNHANCE c1 control = DISABLED
CPU INTERNAL THERMAL CONTROL = DISABLED
VIRTUALIZATION TECHNOLOGY = DISABLED
INTEL SPEEDSTEP TECH = DISABLED
--------------------------------------
JUMPER FREE CONFIGURATION
--------------------------------------
ai overclocking = manual
cpu freq = 400
dram freq = ddr2-600Mhz (PC2 4800)
performance mode = turbo
pci express freq = 100
pci clock synchronization = 33.33Mhz
mem voltage = AUTO
vcore = AUTO
fsb termination voltage = AUTO
mch chipset voltage = 1.55v
ich = 1.20v
digital home mode = disabled
-----------------------------------------------------
hardware monitor
-------------------------------
AI QUIET = DISABLED
CPU FAN CONTROL = DISABLED
--------------------------------------------------

I was wondering how i could make my cpu o'C even more...
i know some ppl have it to 3.5..., or maybe increase the ram frequency..
my pc wonr let me use over ddr2-600(pc24800) it will crush

thanks

 

[killa]

No there is not from my understanding.
It is physically separated.

 

[dark_el_diablo]

what should i change them 2 m8...??? :roll:

hey can someone also explain what ppl mean by 1:1 ration 5:4 i dont get it :S

 

[godman]

it means the ratio:

DRAM:FSB

eg fsb@266mhz

1:1 is in sync with the fsb
ram is working at 266mhz
2:1 means the ram is two times as fast as the fsb. #
ram is working @ 533mhz
5:4 cant be bothered to work out someone else can do this..
etc...

i think its easier to use multipliers rather than ratios..... its easier to work out

 

[dark_el_diablo]

8O :?: i still dont get it :lol: