Getting rid of second area

Archived from groups: alt.comp.periphs.scanner (More info?)

Using a Microtek ScanMaker 4800 and ScanWizard 5 software, when I go
to "Advance Control Panel" I have three scanning areas (outlined by
those famous marching ants). This results in three scans per pass.

I would like to delete two of the three. I can't figure out how using
"Help", the "escape" key or the "delete" key. There must be a way.

Suggestions?

Tony Cooper - Orlando FL

Archived from groups: alt.comp.periphs.scanner (More info?)

On Fri, 04 Mar 2005 09:48:58 -0600, Randy Hills
<randy@chromagraphics.ca> wrote:

>go to view - show scan job window - delete 2 of the 3 scan areas
>
>Randy

Ahhh, well. That did it. Thanks.

Like the song says, I was looking in all the wrong places.

--
Tony Cooper
Orlando FL