right now the pc works wonderful if i have 1 graphics card installed, the problems start when i add the second one in. if i add the second graphics card in SLi mode the pc powers on and such however the montior gives the error message of no signal. tried all connectors nothing works.
now the motherboard does all the checks and i can see everything working, fans going round MB LED is doing its checks but doesnt display any error, so its as if the pc works though it just doesnt know WHICH graphics card it should be displaying from.
now i tried both cards in on thier own so i knew both were working.
power connectors all seem fine, however i didnt know if there was something in the bios or say a jumper connector i had to enable to tell the pc it is in SLi mode though i cant find any mention of such a thing in the manual. i hope you guys could give me some ideas about where to go with this as im stuck now.
