Help: WLNB-AN-DP101 Airborne™ Embedded Wireless Module

Hi,

I tried to connect the WLNB-AN-DP101 to a computer using serial port to communicate using hyperterm for the CLI.

However, port F0 (POST) keeps blinking. Is it normal for it to blink??

I bought a breakout board from http://www.sparkfun.com/commerce/p [...] ts_id=699# to connect to the hirose connector.

I applied 3.3V to DVdd and grounded the GND pins. I also connect F1 and F7 to pins 3 and 2 of RS232 respectively.

Next i run hyperterm. I selected com1, 9600 bits per second, 8 data bits, no parity, 1 stop bit, and hardware flow control.

Is there anything that i have missed out on my connections that causes the blinking??

Thank you in advance.