I overclocked my E6600 (the fsb to 333mhz) on the D975Xbx (rev. 1) motherboard. When I check my overall speed on Cpu z I either get multiplier 6 or 9. When i check core temp, I get (333*9=3000). I'm doing this on stock cooling. My question is, should i over clock this much on stock, and if so, where should I stop. Also, how do I manually adjust the multiplier.
When i run speed fan, i get V1.5 out of range, how do i solve this?
Thanks
****I read wusy's guide very thoroughly before I attempted this.
When i run speed fan, i get V1.5 out of range, how do i solve this?
Thanks
****I read wusy's guide very thoroughly before I attempted this.