Sign in with
Sign up | Sign in
Your question

cpu not reading correct

Last response: in Windows 95/98/ME
Share
February 26, 2006 12:44:17 AM

Hey,
I installed a 'pentium 3 550Mhz' socket type chip after removing a 'pentium 2' slot type chip into a motherboard which has a slot 1 and a socket 370.When I went in to properties in my computer, it read the pentium 2 processor but it was reading the pentium 3 in POST. After reinstalling windows 98 the same problem occured.I also increased the speed in the BIOS according to the processor speed.Also in the 'hardware monitor' in the BIOS it is reading the pentium 2 and 3 chips temperatures even though the pentium 2 is removed.
Can someone tell my how to solve this problem?
Thanks

More about : cpu reading correct

March 24, 2006 10:03:33 PM

open the computer up and remove the battery that is inside you should also have a clear cmos jumper setting make sure the power lead is out, clear the cmos then replace the jumpers to the correct postion.

replace the battery that has now cleared the whole board and has reset it to manufactures standard,

it may have been a case of the bios miss reading the information.
March 25, 2006 7:48:58 AM

Are you sure there's no jumpers that need to be switched around when changing from slot to socket, that perhaps you did not notice?
Related resources
March 26, 2006 1:41:46 AM

no... there are no jumpers.i am going to try what Tron014 told me.thanks for the info. :) 
March 26, 2006 1:45:34 AM

no... there are no jumpers.i am going to try what Tron014 told me.thanks for the info. :) 
!