WRT54GS as an AP

[Improvinkid17]

Hey, I have a little bit of a strange network setup. I want to use a WRT54G as an access point but am using a WRT54GS as the main router. I have taken the time to make a diagram to simplify life. The problem with is that when i set everything up I have to of the same SSID wireless networks. There is no seamless roaming in my house. I have to disconnect from one and log onto the other. To complicate life even more. I am using static IP's on all the computers.

Image
http://f3.yahoofs.com/users/43113dedzf23a3bf8/d695scd/__sr_/a386scd.jpg?phgNwuFBwdGz9UdD

 

[Iceblue]

I am using static IP's on all the computers.

Why??

I couldn't get your image link to work.

 

[Improvinkid17]

Hey, cant get the image to work so I will give u this link

http://ca.pg.photos.yahoo.com/ph/marcellus_loryn/

and tell you to go into the network album. Its the only picture in there.

I am using static IP's because I use terminal services on one computer.

 

[crazyhandpuppet]

I assume you want one router to communicate wirelessly to the other router and act as a repeater? If so, I think you need a 3rd party firmware to enable WDS+AP on them. I tried something like this a while ago, but couldn't get it to work. Good luck.

If you want them connected by wire, just disable DHCP in the router that is not connected to the modem.