E6400 overclocking with DFI Infinity 975X/G

[Porshe1903]

I rised FSB to 300 succesfully. After that i set it to 312 and saved settings and rebooted. Coolers just kept running and computer kept noise but it didnt start to open. It didnt even load bios. I needed to take that bios battery out from my motherboard and set it back. Anybody other had this kind of problem? Do i have to change voltages or something? I have updated my bios.
I have[/quote]
1GB 800 Mhz CL4+512MB 800 Mhz CL5 DDR2 memory and
PSU: Antec Neo HE 430 W
Graphic Card: GTS 8800 320 Mb
:?: :?: :?:

 

[ZOldDude]

I rised FSB to 300 succesfully. After that i set it to 312 and saved settings and rebooted. Coolers just kept running and computer kept noise but it didnt start to open. It didnt even load bios. I needed to take that bios battery out from my motherboard and set it back. Anybody other had this kind of problem? Do i have to change voltages or something? I have updated my bios.
I have

1GB 800 Mhz CL4+512MB 800 Mhz CL5 DDR2 memory and
PSU: Antec Neo HE 430 W
Graphic Card: GTS 8800 320 Mb
:?: :?: :?: [/quote]

First off just use TWO matched sticks of ram.

Also I would use a approved PSU for the MB (and the unit you have is too small anyhow with that GFX card).

Here is Angry Games website and the old offical DFI forum:
http://www.diy-street.com/forum/index.php

After you get everything correct as far as parts you will find that nothing will OC higher than a DFI MB.