Set the SATA function to IDE in the BIOS setup [Normally Default], install the OP/SYS and when the OP/SYS is up and running if you need to enable AHCI [Advanced Host Controller Interface], you can do it from Windows and install the drivers from there, then go back to the BIOS setup and change the SATA function to AHCI.
Unless you're intending on running a RAID array, in that case you will need to go the F6 Floppy Install route unless you slipstream the RAID drivers to the installation CD.
Message edited by 4ryan6 on 09-19-2008 at 03:14:17 PM
------------------------------Badges? We don't need no stinkin' badges!
Reply to 4ryan6
You are about to answer a thread that has been inactive for more than 6 months. If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.