Graphics Card is detected only if standby 5V is on. Tags: Graphics Cards Command Line proton007 October 3, 2012 12:48:17 AM Dear all, I hope you can help me out here. The issue is, the Xorg detects the graphics card only if the 5V standby is on (Read: Mains has not been switched off). If I switch off the mains, wait till the mobo light goes out, and then restart, the system boots to command line. On reboot its ok. I'm using the Radeon HD7850 with the ATI-Catalyst driver. More about : graphics card detected standby Can't find your answer ? Ask ! Publish Related resources: ForumPower on ATX 2.2 PSU/motherboard without + 5V standby ForumGraphic card only sometimes get detected by pc SOMETIMES NOT ForumVoltage readings +12v, + 5v (vcch) too low???? enermax liberty 620W ForumGraphics Card Is Not Being Detected ForumGraphics Card Not Detected ForumPC Hangs After Standby ForumCan a faulty graphics card damage a motherboard / PSU? ForumWin XP stuck in standby mode ForumNO BEEPS & DISPLAY IN STANDBY (a major unsolved problem) ForumUpon connection of dvi-vga converter monitor instantly on standby ForumNo - 5V output, yet still working ForumOnly the standby light seems to work! ForumMy 5v rail isn't reading! Need help fast ForumAdvice on Graphics Card Choice ForumHow can I drive DVI or HDMI from an old fashioned 5V PCI, non express slot? ForumBoot Problems ForumWhich Card is best? for Linux ForumExternal HDD files only visible in Linux. ForumGraphics drivers issue on ubuntu 12.04 ForumBlack screen, CRT monitor only More resources !