E4400 At 2.5ghz little help please

[IKSDoomsday]

Ok so far so good have it up to 2.5ghz on stock voltage running smooth in orthos for 2 hours. My question is about my heat. At idle Core Temp 0.95 reads core 0 at 47c and core 1 at 49c under full load after 10 mins it reads core 0 at 71c and core 1 at 71c. Now speed fan is reading my temps while ide at core 0 32c and core 1 at 34c under load it was reading 55c and 55c. How is that? Oh and tat will not work on my system for some reason. everytime I try to load it my computer bsods. Any help would be much appreciated.

specs:
e4400 1000mhz fsb 2.5ghz (temp chip till newegg gets my e6850 here)
4gigs 800mhz kingston hyper x
evga 680i mobo
thermaltake toughpower 700 modular
evga 8800 ultra 768mb graphics
x-fi extreme gamer fatal1ty pro

 

[drew455]

i would trust core temp but i've had bad luck with that version. for some reason when i use it my computer blue screens. i use core temp version 0.94 and i trust what it tells me. i've also had bad luck with speedfan so i dont know how reliable that is, even tho its temps seem more reasonable. just to be safe i'd try other programs. also check what the bios says.

 

[IKSDoomsday]

Thanks I will try 0.94 out!

 

[IKSDoomsday]

Wow! all I have to say is yes 0.94 works..showing my temps much lower and I believe accurate at 33-35c idle!

 

[k1ngkong]

I have an e4400 w/ a Tuniq Tower on in.

IDLE at 2.4Ghz : TAT reads 45 core0 & 39 core1
Fanspeed read 28 c0 and 23 c1

100% TAT Load: TAT Reads 60/55
Fanspeed reads 47/43

I've heard Fanspeed is usually about 15 degrees off for c2d's and it shows it here too.
I would trust core temp.

BTW what stepping do you have? I have the
Espec: SLA3F
Stepping : L2

 

[IKSDoomsday]

Here is the CPU-Z profile for my system so far.

http://valid.x86-secret.com/show_oc.php?id=226549