I just built my first pc and am a little confused about what my temps should be. I had a tough time getting my arctic cooler freezer 7 pro on which may be why I'm worried. I have an e6750 on a gigabyte p35 ds3r board. I keep reading that I need to add 15 degrees to the temps reported in speedfan and coretemp. Last night I ran Orthos, on each core for about 9 hours. Here are the temps reported by speedfan this morning and shortly after I shut down orthos
Speedfan is 4.32
Coretemp is 0.95
Temp1 45
Temp2 46
Temp3 -2
HD0 36
HD1 37
Core0 43
Core1 43
10 minutes or so later
Temp1 44
Temp2 29
Temp3 -2
HD0 37
HD1 37
Core0 28
Core1 29
Coretemp gives roughly the same temperature (within a degree or so)
Tjunction 85
If I have to add 15 degrees then at load my core temp is 58. The processor is running at stock clock and voltages, although I'd like to overclock a small bit once I'm satisfied that everything is working as it should be at stock. I've several posts on temperatures and I'm just unclear as to what each of the different temps is for (well Temp1 vs Temp2) and whether I need to factor in a 15 degree error.
Speedfan is 4.32
Coretemp is 0.95
Temp1 45
Temp2 46
Temp3 -2
HD0 36
HD1 37
Core0 43
Core1 43
10 minutes or so later
Temp1 44
Temp2 29
Temp3 -2
HD0 37
HD1 37
Core0 28
Core1 29
Coretemp gives roughly the same temperature (within a degree or so)
Tjunction 85
If I have to add 15 degrees then at load my core temp is 58. The processor is running at stock clock and voltages, although I'd like to overclock a small bit once I'm satisfied that everything is working as it should be at stock. I've several posts on temperatures and I'm just unclear as to what each of the different temps is for (well Temp1 vs Temp2) and whether I need to factor in a 15 degree error.