Word :    Username :           
 

I've had this Biostar TForce s939 motherboard for about...10 months, and I recall the aluminum heatsinks on it were always warm to the touch. I just installed SpeedFan for CPU temp monitoring as I've read it's better than CoreTemp, and here are the temps:
http://hidebehind.com/lthumbs/3A/3AE022.jpg

 

I then opened the case (120mm intake/exhaust) and touched them and they are HOT!

 

I'm assuming one is on the onboard video chipset which I'm not using (7600gt).

 

What should I do...what can I do?

 

Message quoted 1 times
Message edited by Noya on 08-22-2007 at 01:16:45 AM
Sponsored Links
Register or log in to remove.

Noya wrote :

I've had this Biostar TForce s939 motherboard for about...10 months, and I recall the aluminum heatsinks on it were always warm to the touch. I just installed SpeedFan for CPU temp monitoring as I've read it's better than CoreTemp, and here are the temps:
http://hidebehind.com/lthumbs/3A/3AE022.jpg

I then opened the case (120mm intake/exhaust) and touched them and they are HOT!

I'm assuming one is on the onboard video chipset which I'm not using (7600gt).

What should I do...what can I do?



You cut the picture off in the middle where no one can see what is being measured, but if you are referring to the 100 + readings with the flames shooting out that is a measurement of very likely...nothing.

Reply to badge

speedfan fills in sensors it doesnt find with 120+ degrees Celcius, they are not valid, nor do they exist, simply disable them from showing.

if you touched a piece of metal thats 127 degrees C you would have burnt your finger, boiling point of water is approximately 100 degrees C ...

Reply to pavel-

pavel- wrote :

speedfan fills in sensors it doesnt find with 120+ degrees Celcius, they are not valid, nor do they exist, simply disable them from showing.

if you touched a piece of metal thats 127 degrees C you would have burnt your finger, boiling point of water is approximately 100 degrees C ...



Are you sure?

I just placed a finger on one of the heatsinks and by the count of three I had to pull it off because of the temp. By contrast, the CPU heatsink feels cool and the GPU heatsink isn't hot either.

SpeedFan shows two 127*c temps and I have two, very hot heatsinks on the board.

Reply to Noya

A couple of well placed intake/exhaust fans might cool down the chips you are finding to be hot to the touch, but the 127 c temps shown by speedfan are programed to look like that when they are not in use by the software.

Reply to badge

Noya wrote :

Are you sure?

I just placed a finger on one of the heatsinks and by the count of three I had to pull it off because of the temp. By contrast, the CPU heatsink feels cool and the GPU heatsink isn't hot either.

SpeedFan shows two 127*c temps and I have two, very hot heatsinks on the board.




Here is the current desktop with speedfan on my FX55 at work. My CPU is 39C. The two 127C readings are not programmed to read the temp of any par of my computer.

http://img489.imageshack.us/img489 [...] toppu4.jpg


Message edited by badge on 08-22-2007 at 02:04:15 AM
Reply to badge

You can click the configure icon and remove the 127 c readings.


Message edited by badge on 08-22-2007 at 02:03:42 AM
Reply to badge

I see yours, look at mine:
http://hidebehind.com/lthumbs/1E/1E6B4B.jpg
http://hidebehind.com/lthumbs/55/55C2B8.jpg

 

And if it's not 127*c, are the chips under the two heatsinks even being monitored?

 

The CPU is a 25, the 7600gt is at about 50, these heatsinks are seriously burning hot in comparison.

Message quoted 1 times
Message edited by Noya on 08-22-2007 at 02:15:58 AM
Reply to Noya

Speedfan doen't measure northbridge temps as far as I know. I've never tried to set it to do that. Speedfan measures CPU, system, hard drives and cpu core temps. You have a Nforce 4 soc 939 MB as I do. I have 3 of them. Two running sli. Like the one I showed you is an FX55 in an ASUS A8N-SLI Premium MB running dual 7600GTs. The NF4 chips do tend to run hot. I have the A8N32-SLI Deluxe with the dual 16 x northbridge running dual 7800GT's. That thing is so hot! It is one of the hottest MB's made. Try and get some intake/ ehhaust fans to create better airflow in your case. That's what I did.

Reply to badge

http://www.digital-daily.com/mothe [...] orce_6100/

It appears the heatsinks can be quite warm.

Scroll up one pic from the bottom, and look at the number on the chip, they match my 127*c degree SpeedFan reading...

Reply to Noya

Are you using a video card or the onboard video? Like I said, I have a hard time cooling my socket 939 NF4 boards (yours is not nf4). My A8N32-SLI 939 drove me nuts trying to cool it. I used multiple case fans. I'll try and get a picture up later. You will be shocked at how I solved the cooling problem on that board.

Reply to badge

The 127 c speedfan reading is a program default that means nothing. This is common knowledge around this Forum.

Reply to badge

Noya wrote :

I see yours, look at mine:
http://hidebehind.com/lthumbs/1E/1E6B4B.jpg
http://hidebehind.com/lthumbs/55/55C2B8.jpg

And if it's not 127*c, are the chips under the two heatsinks even being monitored?

The CPU is a 25, the 7600gt is at about 50, these heatsinks are seriously burning hot in comparison.



My Speed Fan says the same thing 127C, your worrying about nothing. My heat sinks are hot to the point where if I leave my finger on them for two seconds, my finger gets hot. Nvidia chipsets tend to run hotter than Intel chipsets.


Message edited by systemlord on 08-22-2007 at 03:54:18 AM
------------------------------ Intel C2D E6600 @ 3.2GHz * Asus P5E * 2x1 GB Crucial Ballistix Tracers * Raptor X * EVGA Geforce 8800GTX 768MB 651MHz/1525MHz/2100MHz * X-FI Fatal1ty Pro * Enermax Infiniti 720W PSU * Creative THX5.1 * Tuniq Tower 120
Silverstone TJ09 * Windows XP
Reply to systemlord

Pic of my ASUS A8N32-SLI 4800X2. Notice all the fans and the two 7800GTs. @OP...you can reduce the temps on those MB chips with cooling like I did.

http://img301.imageshack.us/img301/9340/img0037ql5.jpg

Reply to badge

Thanks for all the info guys...call me a worry wart lol.

That is a crazy cooling setup! I guess I should mount a 120mm fan to the back of my hard disk bay and upgrade the 120mm intake fan. Maybe pull the CPU duct and add a fan there since the North Bridge? chip is below the CPU socket.

Thanks again.

Reply to Noya

Sounds good Noya. You will lower your NB and cae temps by doing that. GL.

Reply to badge
Tom's Hardware > Forum > Motherboards & Memory > General Motherboard > Are these temps for real?
Go to:

There are 1289 identified and unidentified users. To see the list of identified users, Click here.

Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
They won a badge
Join us in greeting them