Hello,
 
I've not been able to find any posts about a problem I am having.  I switched over to Intel for the first time since the MX Series Pentiums and am having nothing but problems.  I setup my raid 0 array using my new P5K-E board and finally got it to be detected in windows setup.  I complete the first step of the windows install, reboot and then it fails to boot from the RAID array and starts setup from the start again.  If I remove the windows CD it tells me to insert a system disk as it wont boot off the array.
 
I've set it to boot from the Intel Raid array first.  I can load files onto it too with the first stage of windows setup no problem too.  It also detects it fine in the bios and on the Ctrl-I menu screen from the intel raid controller and even says it is bootable.  I even put in a ATA drive in loaded windows and used the array no problem, it just wont detect it to boot from even though it appears in the boot menu.  I updated to the latest BIOS and have the 2 disks in red ports 1 and 2.  Any ideas???