Word :    Username :           
 

Ok I have this board http://www.newegg.com/Product/Prod [...] 3131517and it has worked well for some time and i am using these other parts:

 

http://www.newegg.com/Product/Prod [...] 6819103531
http://www.newegg.com/Product/Prod [...] 6820144112 (x 2)
http://www.newegg.com/Product/Prod [...] 6814130062

 

So had it set up and working for some time. Then I decided to make a new PC, and take some parts from it - the HDs and PSU and make a new system. Well i ordered a hd and a psu for it to have two systems. It was working fine but i think the hooks for the ram slots might have come loose. I know if you are using two memory sticks they have to be dual channeled. I put two memory sticks one in a1 and one in b1 and get no post at all. I put one stick in b1 which is what you do if u are using a solo stick - no dual channel and it works fine. The ram appears to be fully in its slow and doesnt seem to feel loose. I am not sure what the problem might be. I got the manual and can upload it somewhere if needed. (its over 7mb)

 

Well I have tested the Ram and the video card in another system and they both worked fine.I really assume the CPU is fine too.


Message edited by ukbsktbll on 04-04-2008 at 07:38:02 PM
Sponsored Links
Register or log in to remove.
Tom's Hardware > Forum > Motherboards & Memory > General Motherboard > Problems W/ Ram
Go to:

There are 1009 identified and unidentified users. To see the list of identified users, Click here.

Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
They won a badge
Join us in greeting them