So I have a gigabyte ga-p35-ds3p board with F10 bios on it. It had been running about 2 days without issue with a slight overclock. I just went to restart it, the splash screen appeared, then the computer restarted itself. Upon showing the splash screen again, it froze. I tried clearing the BIOS (via the clear CMOS pins and by removing the battery), but both did nothing. So, I figured I might as well leave it on the splash screen to see if anything happens. After about five minutes, the screen changes to say CMOS Checksum error (or something along those lines) with the ability to choose different configurations of last known good boots. I chose default just to be safe. Upon choosing this, my computer restarted itself as expected, then again froze at the splash screen. Waited about 5 minutes, then the computer booted up as normal. Checking CPU-Z, everything is back to default as it should be. I was wondering why my board did this as it is the first time. Everest reports a BIOS battery voltage of 3.25V. Do you guys think that these are signs that my board is going to die soon and I should send it in, or wait it out and see what happens. I'm gonna try restart my computer right now to see if it does it again or not.
So atleast a 5 minute POST. Well, it just freezes, so I can't even go into BIOS. No checksum errors this time, just a freeze during POST. Or well, maybe it's not POST. It freeze during the splash screen, but after it disappears it's works fine. I'm not sure how Gigabyte's do their POST.
Message edited by kkm557 on 05-07-2008 at 11:22:30 AM
In the old days if the board did not like the ram you could get a checksum error. Try swapping it for different ram if you have some or taking out a stick at a time if you have 2 sticks.
Of all the things in the world to cause a checksum error and to slow down POST. It turns out that POST didn't like my older iPod shuffle plugged into it. Since I haven't synced it using this board, it never even crossed my mind. What a waste of time. Back to studying for my midterm.
It is possible that your BIOS somehow got corrupted.
Happened to my P5k a few months back.
Would give me some of the oddest problems.
Random BSODs, long starts and the on board WiFi died.
After reflashing everything started working fine again.
I would recommend you flash (or reflash) your BIOS to the latest version and see if that helps.
---------------
If the automobile had followed the same development cycle as the computer, a Rolls-Royce today would cost $100, get a million miles to the gallon, and explode once a year, killing everyone inside.
PSA
