Tom's Hardware > Forum > Storage > General Storage > Error after new HD put in...
Ask the community Add a reply
Word :    Username :           
 
Tkyle   05-05-2009 at 07:22:24 PM

I just replaced two smaller HD's with a new much bigger one. Now after every start up I get this error and I'm sure it's trying to read one of the two hd's that's not there now. The error is, Drive 1 Not Found: Serial ATA, SATA-1. I'm sure there is a way to go in to Bios or something and make it stop seeing this as it boots up but not sure how. Thanks for any help with this. =)

Add a reply
Sponsored Links
Register or log in to remove.
aford10   05-05-2009 at 10:01:52 PM
- 0 +

Try plugging the new drive into the SATA 1 port on the board.

------------------------------ CM HAF 932 - 300GB Velociraptor
GIGABYTE GA-EP45T-DS3R
E8500 - Sapphire 1Gb 4850
4G DDR3 OCZ Reaper 1333
 Reply to aford10
Ask the community Add a reply
Tom's Hardware > Forum > Storage > General Storage > Error after new HD put in...
Go to:

There are 985 identified and unidentified users. To see the list of identified users, Click here.

Forum map
Bestofmedia Forum ©
2000-2009 Bestofmedia Group
Page generated in 0.126 seconds
Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
Related Topics
See all relatives topics
They won a badge
Join us in greeting them
How do I win badges?