ga-ep35-ds3l memory question

So I put together a new system, but it wouldn't even post unless I used different ram than listed below. From what I've read, my next step is to go into the bios and change the voltage/timings for the RAM and then plug it in and restart. However, I've never done this before, so I'm a little nervous and looking for a "Yeah, that's the right thing to do".

The MB default voltage is 1.8 so I was going to leave that as is and set the latency to 5-5-5-18. Is this correct and should it work? Thanks in advance, specs below:


MB: ga-ep35-ds3l
http://www.gigabyte.com.tw/Product [...] uctID=2778

RAM: Mushkin Enhanced 6400 DDR2
Frequency: 800MHz Latency: 5-5-5-18
Parity: Unbuffered
Voltage: 1.8V Pins: 240
Density > > > Module: 256x64 Chip: 128x8
http://www.mushkin.com/doc/product [...] asp?id=563