i am trying to fix a mouse that is PS/2 but the solder points underneath the board
here is a picture of the PS/2 mouse board:

the mouse wires for PS/2 plug are like this:

Please Help Me!

oh and i am new to the forums
This is my 1st post!

You'd have to probe the end of the ps/2 connector to see what all the wires are for, it seems all manufacturers use whatever the hell color they decide is good.

The Letters on the pcb mean the following V=5v(power), C=clock, D=Data, G=Ground

http://www.mak.co.uk/PS2Guide/kbmsconn.jpg
That might help you figure it out. You should view the diagram as if you where looking directly at the end of the male PS/2 plug that comes from the mouse.
Have fun!

thank you and that picture help out alot
oh and thanks for what V C D G letters on the board means