Hello,
I have an ASROCK board: N7AD-SLI, just installed Corsair 2x2048-6400c4 with timings of 4-4-4-12 @ 800MHz. I have checked on the Corsair forum for the correct settings in the Bios for the latency timing and adjusted them accordingly. However when I manually adjust them my system won't pass the POST and all I get is two long beeps and then it reboots. The system runs normally when I have the timing set to Auto but when I check the latency with CPUZ it is working at these settings:
DRAM Freq 400MHz
CAS# Latency 5
tRCD 5
tRP 5
tRAS 18
tRC 22
Command Rate 2t
I'd like to get this working but perhaps I just bought a crap board or maybe its the RAM?? Any help would be great thanks!
I have an ASROCK board: N7AD-SLI, just installed Corsair 2x2048-6400c4 with timings of 4-4-4-12 @ 800MHz. I have checked on the Corsair forum for the correct settings in the Bios for the latency timing and adjusted them accordingly. However when I manually adjust them my system won't pass the POST and all I get is two long beeps and then it reboots. The system runs normally when I have the timing set to Auto but when I check the latency with CPUZ it is working at these settings:
DRAM Freq 400MHz
CAS# Latency 5
tRCD 5
tRP 5
tRAS 18
tRC 22
Command Rate 2t
I'd like to get this working but perhaps I just bought a crap board or maybe its the RAM?? Any help would be great thanks!