My bios doesn't show up anymore... Help

[kazuya-kun]

I just finished installing my new harddrive and transfered stuff from an old case to a P182 SE.

Anyways, when I boot up, the screen stays blank for awhile then when Vista loads it shows up.

I'm planning on using Arconis 11 to clone the old harddrive into the new harddrive, but I can't do that since when I go to the options (in vista) after all the settings, it reboots to start cloning, but the screen stays blank...

I checked out the Hardrives positions and here's what it says.

New harddrive - Primary Master (empty but I had it partitioned) - SATA 0
Old harddrive - Primary Slave (this one is with all the files/boot) - SATA 1

I'm assuming the old harddrive is one SATA slot behind the new one.

Any know how I can get bios to show up again?

 

[fowang]

probably hitting either the f10/f2 or delete button after you hear the post beep will let you into the bios

 

[knotknut]

Turn off your PC and switch the sata cables on the Motherboard.
Reboot.
When you get into Bios set both drives to master.