There was a time when I had an EVGA 680i mobo. It was a good time. I had my three ATI Radeon X1650's installed and running my six monitors beautifully. For reasons beyond my control, I had to switch to a BFG 680i board. Since I switched, only two of the X1650's are detected.
I am told the third PCI-Express x16 slot only supports x8 pathways; does that mean it doesn't have enough power to supply the card? Is there any other reason the third card is not detected? It's a known-good card.
He is not trying to run CrossFire, he is trying to drive 6 monitors.
To the OP, it should work in X8 mode, it should work in X1 mode albiet very slow. Is there a setting in the BIOS of that board that enables/disables the 3rd slot, or reserves X16 for the second slot (which would in affect shut down the 3rd slot)?
------------------------------Don't go away mad, just go away!
Reply to techgeek
You are about to answer a thread that has been inactive for more than 6 months. If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.