Sign in with
Sign up | Sign in
Your question

please help me! can't load pc

Last response: in Systems
Share
September 24, 2008 5:10:22 AM

please help me... I was tweaking on the bios because i'm ocing,... then suddenly, I tried lowering the vcore to 1.20 then the pc won't even boot to anything! even bios... when i try to go to bios,, it changes screen into a black with an underscore symbol blinking at the corner.. it won't change.. I don't know how to reset the cmos .. please help me! did i break any component inside the pc? will I still be able to fix this? i have a q6600 in a EVGA 650i a1 ultra.. please help me! urgent...

More about : load

September 24, 2008 5:44:40 AM

Read your mobo manual to see where the cmos jumper is.

Or take the battery out 10 minutes.

After that dont mess with it til you read something and you know what your doing. It is not a toy.
September 24, 2008 8:50:18 AM

but did i damage anything?
Related resources
September 24, 2008 8:54:10 AM

You probably didn't break anything. PC components are delicate but not THAT fragile.
September 24, 2008 8:55:52 AM

how would i know if i damaged anything?how bout the cpu?
September 24, 2008 8:59:16 AM

You won't really know if you've damaged anything unless it's obvious that a capacitor popped or the computer just won't turn on even after you reset the BIOS. After that the only way to know if you broke something is if your computer keeps giving you random errors.
September 24, 2008 9:00:15 AM

Bottom line: OC'ing is not hard, but make sure you know what you're doing.
September 24, 2008 9:00:37 AM

if i put on the bios update disk and try to reupdate, will that do the job?
September 24, 2008 9:33:27 AM

Just reset your bios for now. Read your manual and reset the jumper, that should do the job. Don't bother updating the bios.
September 24, 2008 10:09:45 AM

how do i reset the cmos jumper?
September 24, 2008 10:10:39 AM

i've read the manual. but I don't know how to do it..
it says

1. Turn off the AC power supply and connect pins 1 and 2 together using the
jumper cap.
2. Return the jumper setting to normal (pins 2 and
3. Together with the jumper cap).
4. Turn the AC power supply back on.
September 24, 2008 10:18:02 AM

there are 3 pins.. and the jumper is connected to the 2 right pins..
do i need to switch it to the 2 left pins and power on?or switch it back to the 2 right pins and then power on?
September 24, 2008 4:17:23 PM

Okay.

Take out the jumper and connect it to the 2 left pins. Leave it there for like a minute, then take it put it back on the 2 right pins. Voila, Bios is resetted.
!