Sign in with
Sign up | Sign in
Your question
Solved

Guys need help with overclocked i7-930

Last response: in Overclocking
Share
April 4, 2010 6:52:32 PM

when i overclock cpu just a little bit from 2.8 to 3.2 and set ram speed to 1600. i cant boot the windows plus i need reset the bios because my pc just freez, i cant even go to the bios. But if i put my ram speed down to 1066 every thing is fine. can some body help my?? planing to overclock to 4.0 ghz

More about : guys overclocked 930

April 4, 2010 7:28:56 PM

have you tweaked the vcore ? Also check your ram timing and you qpi should be lowered. Whats your power supply ?
m
0
l
April 4, 2010 10:09:36 PM

Yea need a lot more information to help you. I'm assuming you haven't touched the bios yet?
m
0
l
Related resources
April 4, 2010 10:19:56 PM

i have antec 1200 W, and yes i touched the bios. i am new to i7 overclocking it is a little different than oldest cpu. i used overshoked's post to overclock the cpu
m
0
l
a b å Intel
a c 155 K Overclocking
April 4, 2010 11:51:30 PM

What is your RAM rated at ?

Have you run Memtest+ (12-18 passes) on it at the rated speed ?
m
0
l
April 5, 2010 12:05:02 AM

Post all your bios voltage settings. Have you upped the voltage of your ram for it's rated speed/timings?
m
0
l
April 5, 2010 1:22:46 AM

CORSAIR DOMINATOR-GT 6GB 7-7-7-20 1.65 V. no i did not run memtest 86.
m
0
l
April 5, 2010 3:31:20 AM

matvey said:


Your image isn't working...you need to upload it to the internet using photobucket, etc.
m
0
l
April 5, 2010 3:47:24 AM

Best solution

April 5, 2010 3:54:15 AM

Is your QPI frequency selection set to the lowest value?

Change your CPU VTT to 1.3v to start, and set your CPU PLL to 1.8v.

Just remember your CPU vcore and CPU VTT are the most important voltages in overclocking.

Taking a look at this guide will surely help you more:
http://www.overclock.net/intel-cpus/538439-guide-overcl...
Share
April 15, 2010 12:17:59 AM

Best answer selected by matvey.
m
0
l
!