how to set the jumper setting in both hdd one of ibm and other sata
sandeepkasetty Distinguished Feb 23, 2009 1 0 18,510 Feb 23, 2009 #1 how to set the jumper setting in both hdd one of ibm and other sata
todd5854 Distinguished Feb 8, 2009 163 1 18,690 Feb 23, 2009 #2 On most motherboards I don't think it matters.
kyeana Distinguished May 21, 2008 1,290 0 19,310 Feb 23, 2009 #3 sense you are referring to jumpers, im assuming that the ibm HDD is an IDE? If so just connect the SATA one normally, and make the IDE one master.
sense you are referring to jumpers, im assuming that the ibm HDD is an IDE? If so just connect the SATA one normally, and make the IDE one master.
M mike99 Distinguished Sep 9, 2006 1,026 0 19,290 Feb 23, 2009 #4 SATA, no jumpers as no mastser/slave. IDE on its own, better if CS (Cable Select) on the end connector. Mike.
SATA, no jumpers as no mastser/slave. IDE on its own, better if CS (Cable Select) on the end connector. Mike.