Belkin F5D7230 WAP as wireless bridge

I've been using this WAP to connect my laptop. I got a webcam and have had to run a long ugly cable from my router to my living room where the camera is located. I want to configure the Belkin WAP as a wireless bridge. There's a setting in it's configuration page. I bought a new wireless router, a Netgear WNR834Bv2. My laptop connects successfully to the new router. Now I want the camera to use the Belkin F5D7230 to connect wirelessly, but I can't see the WAP once I disconnect it from the router. Both the router and the WAP have a WAN and LAN MAC address and a place to enter MAC addresses. The Belkin has a page "Wireless>MAC Access Control" where I enterd the wireless MAC address of the router and the MAC address of the camera. It also has a page "Wireless Bridge" where I entered the LAN and WAN addresses of the router. What else do I need to do to see the WAP and camera once I disconnec the WAP from the router?