When I run a prime95 blend test my computer is restarting without any BSOD, what could be the cause of this? I am not sure what voltage I should be increasing/decreasing.
Settings:
Multipler [x20]
BLK [169]
Boost [Enabled]
C1E [Disabled]
C3/C6/C7 State Support [Disabled]
CPU Thermal Monitor [Disabled]
CPU EIST Function [Disabled]
QPI Clock Ratio [Auto]
Performance Enhance [Turbo]
System Memory Multiplier [Auto]
DRAM Timing Selectable [Quick]
CAS Latency Time [8]
tRCD [8]
tRP[8]
tRAS[24]
Command Rate [Auto]
Vcore 1.2375
QPI/Vtt 1.315
IOH [Auto]
DRAM Voltage [Auto]
Hardware:
i7 920
gigabyte x58a-ud3r
corsair 650w
ocz 1600 gold (3 x 2GB)
Settings:
Multipler [x20]
BLK [169]
Boost [Enabled]
C1E [Disabled]
C3/C6/C7 State Support [Disabled]
CPU Thermal Monitor [Disabled]
CPU EIST Function [Disabled]
QPI Clock Ratio [Auto]
Performance Enhance [Turbo]
System Memory Multiplier [Auto]
DRAM Timing Selectable [Quick]
CAS Latency Time [8]
tRCD [8]
tRP[8]
tRAS[24]
Command Rate [Auto]
Vcore 1.2375
QPI/Vtt 1.315
IOH [Auto]
DRAM Voltage [Auto]
Hardware:
i7 920
gigabyte x58a-ud3r
corsair 650w
ocz 1600 gold (3 x 2GB)