RPC Call Locator error 1068

Go to Control Panel>Administrative Tools>Servicves and scroll through the list to RPC Locatorand make sure it's set to Automatic. Also, check that the Service on which it depends - Workstation - is also set to the same and change them if they are not. Restart the computer and check again.

What do you think started this problem and if it was malware, have you completely removed it?

Hi,

Go to Start / Run and type in "services.msc" without quotation marks, then press Enter or click OK.

In the window that opens (Services) look for "Print Spooler" on the right

Right-click "Print Spooler" and select "Properties".

Click on the "Recovery" tab and change all 3 drop-down boxes to "Restart The Service".

Make sure the 2 text boxes underneath say "1" in them.

Click Ok until you are back at the Services window, close it and you're good to go.

Go back into the properties of the "Print Spooler" tab and be sure to click Start to restart the Print Spooler service and it will restart the service immediately.

The Print spooler depends on the Remote Procedure Call (RPC) service. Is this service disabled? Go to services.msc look for RPC. Check state: Automatic