Sign in with
Sign up | Sign in
Your question

Disk Boot Failure Insert System Disk...

Last response: in Motherboards
Share
June 5, 2009 6:09:23 AM

Had to replace a hard drive on a P4 PC. The original HD had a Sata connection to the motherboard with an IDE connection for electricity. I bought a new IDE HD and installed it and installed Office, etc and everything was fine. Now I get the message Disk Boot Failure. When I put in the installation CD it boots fine. I went back into the BIOS and disabled the Sata on the motherboard thinking the PC might be looking for the sata connection. Still get the same message. WHat can I do?
June 5, 2009 12:59:32 PM

Maybe the two aren't related. Someone told me that the cmos should be reset after swapping out a component and u might want to check out your ram--take it out and try each stick in the first slot.
Related resources
!