Settings:
Router1:
eth2+eth3 = bridge1
eth1=WAN(Internet)
Bridge1= IP: 192.168.1.1/24
src-nat src address: 192.168.1.0/24, action:masquerade
routing: dst-address: 192.168.2.0/24 gateway: 192.168.1.2
dst-address: 192.168.3.0/24 gateway: 192.168.1.2
Router2:
Eth1 IP: 192.168.1.2/24
Gw: 192.168.1.1
routing: dst-address: 192.168.2.0/24 gateway: 192.168.2.2
dst-address: 192.168.3.0/24 gateway: 192.168.2.2
src-nat src address: 192.168.2.0/24 masquerade
src-nat src address: 192.168.3.0/24 masquerade
wlan1 in ap-bridge mode: IP: 192.168.2.1/24
On network 192.168.2.0/24 runs DHCP server giving devices connected to AP(wlan1) ip addresses(ip pool: 192.168.2.2-192.168.2.254, network: 192.168.2.0/24, gw: 192.168.2.1)
Router3:
wlan1 in station-mode, dhcp-client(gets ip dhcp lease: 192.168.2.2/24, gw:192.168.2.1)
eth1: IP: 192.168.3.1/24
I want to change router2, but other routers are still power on(must be), but the same settings in that I want to put on place of router2(just restored backup), but doesnt work, there is no firewall, na arp-only. I cant ping after change router1 neither router3, I tryed 2 devices, I tryed ros3, ros2. Router1 is running on ros 2.9.51, router2: 2.9.51, router2: 3.20.
Can you please help what can be wrong, I try this prety long, also I tryed to set router2 from beginning(after reset), I dont know what to do now.
Maybe some mistake in settings but I dont think.