Sign in with
Sign up | Sign in
Your question

NEED HELP..Antec 902 FRONT PANEL AUDIO STATIC

Last response: in Components
Share
May 23, 2009 2:34:00 AM

Hi everyone.
I recently bought the Antec 902 case to replace my old modded cheap one..Problem is whenever I use the front panel audio out jack, I hear an irritating continous static. The rear I/O panel audio jacks does not share the problem.
What's causing this static? Is there any way to fix it?
Any help will be appreciated.
May 31, 2009 8:32:54 AM

The Antec 902 should come with 2 connections for the front audio audio jacks. There is an AC’97 and a HDA connector, make sure you have the correct one connected, and make sure you have it connected to the correct port. If you know you have it connected to the correct port, then try switching to the other connector. More importantly, if you are use an extender to lengthen the cable, that might be allowing noise interference, ESPECIALLY if the extender isn't shielded.
November 7, 2009 11:45:31 AM

Sorry I couldn't respond earlier. And thanks for your reply.
I'm not using any extender. My mobo's audio is HD, so I connected the HD connector. and I'm sure about it.
Related resources
November 7, 2009 7:37:01 PM

I have the same problem w/my antec 300 and the headphone out port.
November 8, 2009 2:00:42 PM

@Sparky
What mobo and how do you route the cable of FP audio?
!