Hey,
I'm putting to together a new build atm.
I have 2 USB's on the front panel of the case.
They each have these 4 labelled leads data +1, data -1, gnd 1 and VCC1.
Below is a picture of my motherboard manuals USB connect points.
I'm assuming data +1 would go to 5 or 6.
data -1 to 3 or 4.
gnd 1 to 7 or 8.
I don't know where VCC would go to. Any ideas? I'm not even sure what VCC stands for.
Are my connection points for the others right too?
I assume I can connect both USB slots to those 10 connectors as there are 2 of each type.
Thanks for any help.
I'm putting to together a new build atm.
I have 2 USB's on the front panel of the case.
They each have these 4 labelled leads data +1, data -1, gnd 1 and VCC1.
Below is a picture of my motherboard manuals USB connect points.
I'm assuming data +1 would go to 5 or 6.
data -1 to 3 or 4.
gnd 1 to 7 or 8.
I don't know where VCC would go to. Any ideas? I'm not even sure what VCC stands for.
Are my connection points for the others right too?
I assume I can connect both USB slots to those 10 connectors as there are 2 of each type.
Thanks for any help.