Wich parameters to bring 875k to 4ghz??

writerclock

Distinguished
Oct 21, 2010
1
0
18,510
dear all, I need your help to overclock my 875k (on mb ASUS 1156 Maximus III GENE).
Here my bios, can you suggest me what settings update/change to start a first overclock of my cpu?

thank you very much for assistance

MY BIOS NOW

CPU LEVEL UP: AUTO (valori lynnfield 3.08, 3.2 - 3.52)
MEMORY LEVEL UP: AUTO
turbo mode core ratio offset 1,2,3,4: all on auto

AI OVERLCLOCK TUNER: AUTO, with MANUAL:

BCLK: 133
PCIE: 100
DRAM frequency: auto
QPI frequency: auto
CPU RATIO SETTING: auto

intel speedstep: enabled
intel turbomode: enabled

DRAM TIMING CONTROL
dram cas latency: 9 auto
dram ras to cas 9 auto
dram ras pre time 9 auto
dram ras act time 24 auto
dram ras to ras delay: 4 auto
dram ref cycle time:74 auto
dram write tecovery time: 10 auto
dram read to pre: 7 auto
dram four act win:20 auto

dram timing mode: 1n auto
dram round trip latency on chab 53 auto

dram write to read delay dd: 5
dram write to read delay dr: 5
dram write to read delay sr: 16
dram write to write delay dd: 10
dram write to write delay dr: 10
dram write to write delay sr: 10
dram read to read delay dd: 7
dram read to read delay dr: 6
dram read to read delay sr: 4
dram write to write delay dd: 7
dram write to write delay dr: 7
dram write to write delay sr: 4


LN2 mode: disabled
cpu clock amplitude: auto
pch clock amplitude: auto
cpu clock skew: auto
pch clock skew: auto
extreme OV: disabled
full phase control: full phase
load line calibration: auto
cpu voltage mode: vid
cpu voltage: auto current voltage: 1.124 1.799 1.124
cpu pll voltage: auto
imc voltage: auto current 1.085v
pch voltage: auto
dram voltage: auto

dram data ref e ctrl ref volt.: auto
cpu spread spectrum: auto
pcie spread spectrum: auto

c1e support: enabled
hw prefetcher: enabled
adiacent line prefetcheer: enabled
max cpuid value limit: disabled
intel virtualization tech: enabled
cpu tm function: enabled
execute disable bit capability: enabled
intel HT technololgy: enabled
active processors cores : all
a20m: disabled
intel speedstep tech:enabled
intel turbo mode: enabled
intel C-STATE TECH: enabled


MY RAM

mushkin
Redline DDR3 Dual Kit
Red Frostbyte Edition
Specifi cations:
Memory Type: PC3-12800U (DDR3-1600)
Memory Size: 2x 2048MB DIMMs
DIMM Type: DIMM 240-pin

Latency: CL6
Voltage: 1.65 Volt
Heatspreader: Red Frostbyte

Timings:

CAS Latency (CL): 6
RAS-to-CAS-Delay (tRCD): 8
RAS-Precharge-Time (tRP): 6
Row-Active-Time (tRAS): 2
 
Disable CPU level Up to MANUAL
Set Turbo to 4
AI Overclock Tuner: MANUAL
QPI 6.4 GT/s
Set CAS to 7-7-7-21
Enable Extreme OC
Set Memory Voltage to 1.6500V



For being Mushkin RAM, it should be solid. What is your Motherboard?