I have a Gigabyte GA-MA770-UDP3 and OCZ OCZ DDR3 PC3-14400 Platinum Edition ram
My system used to by impossible to run, so I uped the voltage from default 1.5v to the manu specs of 1.95. But, again I get these Error code 0000007f about 1 out of every 4 boots ups. So I decided to manually set the voltage in the mb bios. it was auto 7-7-7-30. I changed it to manu. specs 8-8-8-27. Could this of been the problem? Will it hurt anything by setting the timings to this manually?
Message edited by dman777 on 09-20-2009 at 06:45:42 PM
no, these problems occurred before i set the timings manually. would setting these timings manually damage anything? and could of this been the problem before setting the timings manually?
i ran mem test manually before and after and could never get any errors.