Overlocking i7-930 with ASUS Rampage III

Want to achieve 3.8GHz with my current setup. I'm semi-new to overclocking, so any assistance would be greatly appreciated.

Current Build:
COOLER MASTER Storm Scout
http://www.newegg.com/Product/Product.aspx?Item=N82E16811119196

Corsair H50
http://blog.corsair.com/?p=987

Intel Core i7-930 Bloomfield 2.8GHz
http://www.newegg.com/Product/Product.aspx?Item=N82E16819115225

16GBs of G.SKILL Ripjaws Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800)
http://www.newegg.com/Product/Product.aspx?Item=N82E16820231314

EVGA 012-P3-1472-AR GeForce GTX 470 (Fermi) SuperClocked 1280MB 320-bit
http://www.newegg.com/Product/Product.aspx?Item=N82E16814130549

ASUS Rampage III Gene
http://www.newegg.com/Product/Product.aspx?Item=N82E16813131658

CORSAIR CMPSU-750TX 750W ATX12V / EPS12V
http://www.newegg.com/Product/Product.aspx?Item=N82E16817139006

Samsung 256GB SSD Hard Drive
(MMDPE56G5DXP - 0VBD1)


Also, here is my BIOS template:
[cpp]Target CPU Frequency XXXXMHz
Target DRAM Frequency XXXXMHz

LN2 Mode []***
QPI Loadline Calibration []***

Sync Mode []
AI Overclock Tuner []
OC From CPU level Up []
CPU Ratio Setting []
CPU Turbo Power Limit []

>CPU Configuration----------------------------
CPU Ratio Setting []
C1E Support []
Hardware Prefetcher []
Adjacent Cache Line Prefetcher []
Intel(R) Virtualiyation Tech []
CPU TM Function []
Execute Disable Bit []
Intel(R) HT Technology []
Active Processor Cores []
A20M []
Intel(R) SpeedStep(TM) Tech []
Intel(R) C-STATE Tech []
C State package limit setting []
----------------------------------------------

BCLK Frequency []
PCIE Frequency []
DRAM Frequency []
UCLK Frequency []
QPI Link Data Rate []

Memory Configuration Protect []

>DRAM Timing Control--------------------------
CAS# Latency []
RAS# to CAS# Delay []
RAS# PRE Time []
RAS# ACT Time []
RAS# to RAS# Delay []
REF Cycle Time []
WRITE Recovery Time []
READ to PRE Time []
FOUR ACT WIN Time []
Back-To-BackCAS# Delay []

Timing Mode []
Round Trip Latency on CHA []
Round Trip Latency on CHB []
Round Trip Latency on CHC []

WRITE To READ Delay(DD) []
WRITE To READ Delay(DR) []
WRITE To READ Delay(SR) []
READ To WRITE Delay(DD) []
READ To WRITE Delay(DR) []
READ To WRITE Delay(SR) []
READ To READ Delay(DD) []
READ To READ Delay(DR) []
READ To READ Delay(SR) []
WRITE To WRITE Delay(DD) []
WRITE To WRITE Delay(DR) []
WRITE To WRITE Delay(SR) []
----------------------------------------------

CPU Differential Amplitude []
CPU Clock Skew []
IOH Clock Skew []
------------ Extreme Engine Digi+ ------------
Digi+ PWR Mode []
PWR Volt. Control []
Load-Line Calibration []
CPU Voltege OCP []
CPU PWM Frequency []

Extreme OV []
Extreme OC []

CPU Voltage []
CPU PLL Voltage []
QPI/DRAM Core Voltage []
DRAM Bus Voltage []

>DRAM REF Voltages----------------------------
DRAM DATA REF Voltage on CHA []
DRAM CTRL REF Voltage on CHA []
DRAM DATA REF Voltage on CHB []
DRAM CTRL REF Voltage on CHB []
DRAM DATA REF Voltage on CHC []
DRAM CTRL REF Voltage on CHC []
----------------------------------------------

IOH Voltage []
IOH PCIE Voltage []

ICH Voltage []
ICH PCIE Voltage []

---------- Spread Spectrum Control -----------
CPU Spread Spectrum []
DRAM Spread Spectrum []


***on-board jumper dependant[/cpp]
1 answer Last reply
More about overlocking asus rampage
  1. you are not getting any replies because you ask the same exact stuff other people ask...no offense...but ado a bit or research...read some guides...then try it out...
    If you encounter problems or something...or if you have a specific question then post it here...then you will get a way higher chance of getting an answer...

    don't take this in any offensive way...it's just that I see these kinds of threads at least 5 times a day going through the threads and it gets tiring answering the same stuff over and over again...there are a lot of guides out there...
Ask a new question

Read More

Overclocking Product