Overclocking a 1075t

[oparadoxical_]

I got my Zalman CNPS10x Performa installed today and it lowered my temps by a lot. So now I am trying for my goal of a stable 4+GHz overclock. So far, I have gotten it to run stable for close to an hour before it BSOD. That is my CPUID validation to show some of the setting I had.

That is a picture of the temps I was getting, and several CPUID tabs open to show some different info on what I had.

Anything that I could improve on this to get it stable for more than an hour? And are those temps fine? The core temps never got over 54C, but what is the TMPIN0? That got close to 64c and mostly stayed around 59C. Thanks for any help!

 

[bsnowman17]

Lower NB, HT, and Ram to default freqs, TEMP0 is your actual CPU temp. I have a 1075t and the cpu temp is hotter than the core temps also, but you should use the TEMP0. The max temp for the 1075t is 62C.

 

[simon12]

The voltage and temps are going higher than whats safe. Also set the command rate on them ram to 2T. Please advise what you have set the CPU voltage to in the bios.