? about push-pull HSF setup
Last response: in Overclocking
I have the Cooler Master RR-910-HTX3-G1 with one 92mm fan. Had to go with that because of space limitations. When the CPU load gets cranked up, so does the fan RPM, obviously. If I were to put a second fan on in a push-pull configuration, would both fans run a little slower and provide the same amount of cooling as a single fan at higher RPM?
And how does the fan control regulate the speeds of 2 fans?
Thanks!
And how does the fan control regulate the speeds of 2 fans?
Thanks!
More about : push pull hsf setup
Technically push pull works in brings a minor decrease in temps... use a Y splitter to connect the two fans to the same connection to achieve control over both... the second fan cable should have only the red and black since the rpm feedback should be sent from one fan only... a cable like this would work http://www.newegg.com/Product/Product.aspx?Item=N82E168...
Related ressources:
- ForumPush/Pull HSF setup How to connect to MOBO
- ForumDo you need an exhaust fan when you have a push/pull HSF ?
- ForumDoes a ' Push-Pull ' Setup Decrease CPU Temps?
- ForumDoes Push/Pull System in CPU heatsink work?
- ForumHyper 212+ Push-pull question
- ForumPush+Pull or Push+Push Dual Fans on Heat Sink
- ForumPush/Pull Set-up for the H100(HAF-X case).
- ForumPush/Pull Setup Question
- ForumPush/Pull Fan Setup
- ForumAMD Phenom II 965 BE -- Good, easy-install HSF ?
- ForumFans for Push/Pull on Hyper 212 Plus
- ForumCorsair H100i push/pull quick question
- ForumI5-3750k + H60 push/pull
- ForumFixed Voltage
- ForumWatercooling setup
- ForumDo people really care about power use ?
- ForumQuestion About Overclockin' Athlon II X4 640 Propus
- ForumLeaky WC setup?
- Forum[Solved] Need a new HSF for HD 5770
- ForumTake out Mobo to install new HSF?
- More resources
Read discussions in other Overclocking categories
!
