So I installed my SSD a few days ago( clean install, AHCI, Intel f6 drivers - (shows up as MS drivers on device manager, but that's a different story)) and did some benchmarks.
WEI was 7.7 and ATTO got up to the 280 range so I know those look ok.
Can someone help me figure out if these Crystal Disk Mark numbers look good? I know these numbers will be lower than the ATTO numbers.
Sidenote: The OCZ site you can check your firmware version through CrystalDisk. I don't see it anywhere.
WEI was 7.7 and ATTO got up to the 280 range so I know those look ok.
Can someone help me figure out if these Crystal Disk Mark numbers look good? I know these numbers will be lower than the ATTO numbers.
Sidenote: The OCZ site you can check your firmware version through CrystalDisk. I don't see it anywhere.