Boot probs with 9.5 drivers 4770 crossfire

[ac3144]

Anybody else getting a problem with this? I have 2 4770's (1 x Sapphire, 1 x XFX). Since I have upgraded the driver I get a BSOD with STOP:0x0000007F error message.

Other times it may boot fine, but I can only gaurantee a boot to windows by going back to last known good configuration.

I haven't tried systematically fixing this error yet just wondered whether anyone else has had this problem.

Q6600 @ 2.4
Gigabyte EP45-DQ6
8Gb Corsair XMS2
Jeantech Storm 750W(I know I was desperate)
GPU's as above

Thankyou hive mind
Andy

 

[successful_troll]

Ati

The Way It's Meant Not To Be Played

 

[ajcroteau]

You might want to check to see if you have the latest BIOS or firmware for your motherboard. There might also be a setting in the BIOS to let your machine know you want to run in Crossfire mode.

The other thing i can think of is, my motherboard has a small card that i have to flip around if i want to run it in SLI mode or not. I'm curious if your crossfire board might have the same thing. I don't have experience with crossfire or those motherboards but just trying to think of the obvious things first.

Worst case scenario, you might just have a bad motherboard...

AJ