Sign in with
Sign up | Sign in
Your question

Original WD raptors 10krpm drives... do I need jumpers to install raid

Last response: in Storage
Share
December 15, 2010 4:42:52 PM

I have two 150gig raptors.

No jumpers installed on them.

I want to run RAID 0 on old 939 board.

Do I need jumpers???
a c 372 G Storage
December 15, 2010 4:59:16 PM

I don't think raid has anything to do with it. If it uses the older IDE/PATA connectors then it will require a master/slave designation if they are both on the same IDE controller. If they are on separate IDE controllers, they need to be in single mode.

If they are SATA, no jumpers should be necessary.
m
0
l
December 15, 2010 5:36:25 PM

yes they are sata
m
0
l
!