Sign in with
Sign up | Sign in
Your question

I keep getting a no signal messsage its only after recently installing some more

Last response: in Motherboards
Share
Anonymous
a b U Graphics card
a b V Motherboard
October 25, 2009 10:16:44 AM

i installed new graphics card set it all up comp. was fine i then bought some more memory to boost it up to 3gb a couple of boots after installing these two pieces my comp. will not boot at all it sounds like there is power to my hard drive and evrything else but i get a no signal message on my monitor and the monitor then goes into standby can anyone shed any light on what might be the matter
a b U Graphics card
a b V Motherboard
October 25, 2009 11:38:03 AM

Probably the easiest thing to do is re-install the drivers for your card...
Also if you could post your system specs..including the power supply...
JQ
a b U Graphics card
a c 234 V Motherboard
October 25, 2009 12:43:54 PM

Quote:
i installed new graphics card set it all up comp. was fine i then bought some more memory to boost it up to 3gb a couple of boots after installing these two pieces my comp. will not boot at all it sounds like there is power to my hard drive and evrything else but i get a no signal message on my monitor and the monitor then goes into standby can anyone shed any light on what might be the matter
Does it work if you remove the new memory modules?
Related resources
Anonymous
a b U Graphics card
a b V Motherboard
October 25, 2009 3:14:17 PM

no nothing at all removed the graphics card as well
Anonymous
a b U Graphics card
a b V Motherboard
October 25, 2009 3:15:41 PM

GhislainG said:
Does it work if you remove the new memory modules?





no nothing at all removed the graphics card as well
!