I just invented in a couple of cool Hd's, and activate the onboard Raid in the BIOS, and setup the image and installed Windows, and everything is happydays ... More or less!
Problem is now, that the post-boost screen (where is counts RAM and all that funky stuff), is "blinking" for a second, and then it enters the RAID-utility ... thus making it impossible for me to enter the BIOS of the board! :-s
Any of you have had this problem?
I am running the F6 BIOS, which has been real great, and no complaints at all.
Note: it's not the Raid on the Gigabyte-sata chip ... but the Intel's Southbridge.
Hope you got some advice for me other than the obvious BIOS reset (which I'd really prefer to avoid).
You say the computer POST's, then "enters" the RAID utility.
1) Is that to say that it literally enters the utility, where you go to configure and created RAID arrays?
Or 2), does it POST, then goes quickly to the RAID utility, and then begins to load Windows?
If 2), then the computer is POST'ing very fast and you simply have to be quicker when hitting the appropriate key (DEL, F1, F2, etc...) when trying to enter the BIOS.
As a rule of thumb, a good time to hit the key to enter the BIOS is a second after you hear the beep recognizing the cpu during POST.
You say the computer POST's, then "enters" the RAID utility.
1) Is that to say that it literally enters the utility, where you go to configure and created RAID arrays?
Or 2), does it POST, then goes quickly to the RAID utility, and then begins to load Windows?
If 2), then the computer is POST'ing very fast and you simply have to be quicker when hitting the appropriate key (DEL, F1, F2, etc...) when trying to enter the BIOS.
As a rule of thumb, a good time to hit the key to enter the BIOS is a second after you hear the beep recognizing the cpu during POST.
It's option Nr 2.
I've been pressing the DEL continously, holding it down and whatnot ... and still no go :-\
I would agree that it seemed the most locigal option, that I just need to be faster ... but trying that already, I had hoped there were an easier option :-\
You really want to be at BIOS F9h with that thing - but it won't matter to the BIOS entry issue; a really fast machine, in good working order, posts so quickly, you really don't get a chance to 'see it', it's over by the time: it activates and updates the screen the first three lines (BIOS rev, CPU, and the start of the memory ennumeration; your retina sends the signal to your visual cortex, goint through three separate geometric transforms on the way; your visual cortex 'splits' the signal, sending it to the spatial recognition subsystem, and the pattern recognition subsystem; they both arrive (unbelievably) somewhat 'staggered' at the pre-frontal cortex - who says 'oh - time to hit the <DEL> key', and sends out the command impulse; the command impulse arrives at the neural plexus in the wrist, which (specialized by a couple million years of evolution) is responsible for such varied activities as delivering a winding-trap block in Win-Chun, playing a Chopin etude on the piano, or touch-typing, finally moves the selected finger... By this time, the CPU has finished its memory ennumeration, said a pleasant 'good morning' to all its hardware appendages, had breakfast, and has logged onto the internet, looking at 'computer porn' - probably greedily slobbering over that F9h BIOS I mentioned! Trick is to start 'pecking like a woodpecker' at that <DEL> key immediately on power-up, and, turn off the 'splash' screen in the BIOS. I was all enthused when I found out I could change the splash screen, had this in mind:
when I discovered that the splash screen is just a hindrance and an annoyance when you want to get actual work done in the BIOS!