Gigabye GA-EP45-UD3R Corsair CM2X2048-8500C5G

[goxija]

I have a Gigabye GA-EP45-UD3R, Intel Core2 Q9400, 4g Corsair CM2X2048-8500C5G, Patriod warp 32gb SSD, I just removed a ST3320620AS and ST3500320AS from the system. the video card is a ATI 3550. I get alot of errors in memtest and have tried following some of the directions on Corsair Ram Guy forum without success http://forum.corsair.com/v3/showthread.php?t=78519&highlight=boot+loop. Any thoughts.

 

[goxija]

Oh I forgot to mention that I am running the F11 bios on the gigabyte board.

Thanks

 

[jsc]

Clear your CMOS memory and try with factory defaults.

Then set RAM voltage to Corsair recommended values.

 

[goxija]

Have tried that already, I could get to work by setting the ram voltage to 2.1, the MCH to 1.3 and dialing back the ram to 800 mhz but only in single channel mode.

 

[jsc]

Stupid question: do you have them in the same colored slots?