Sign in with
Sign up | Sign in
Your question

Antec 902 under pressure!!

Last response: in Components
Share
September 17, 2009 1:27:53 AM

Hmmmm...well i wasn't really sure how to title of the scenario I have, but I just put a machine together with the antec 902. The part where cable management is was sticking out too much, so required me to use a little bit of force to close the case. Is this bad? It didn't need like a very hard push, just a small one. I'm pretty sure I can see a slight bulge on the side though DX.

More about : antec 902 pressure

a b ) Power supply
September 17, 2009 1:47:21 AM

You're probably fine, if you are satisfied with the quality of your work.

I wouldn't be lol.
m
0
l
a c 248 ) Power supply
September 17, 2009 3:50:00 AM

I assume you mean you have quite a few cables between the motherboard tray and the right side panel. A tight fit happens quite often. It's okay. Don't worry! Be Happy! :) 
m
0
l
!