D-TEK fusion v2 mounting kit for skt 1366

[expat]

hi,
i have an d-tek fusion waterblock which only fits skt 775.
is there an conversion kit to change it to 1366 compatability.
if so where do i buy
thx rob

 

[rubix_1011]

I found this on their own store:

http://www.dtekcustoms.com/fuzionintelcorei7lga1366pro-mountset.aspx

(BTW...I have that same block...curious how well it performs on newer 1366 vs. 1155 i7's)

 

[expat]

I found this on their own store:

http://www.dtekcustoms.com/fuzionintelcorei7lga1366pro-mountset.aspx

(BTW...I have that same block...curious how well it performs on newer 1366 vs. 1155 i7's)

thx rubix,

but every site i have found the pro mount kit they always seem to be out of stock.
perhaps the pro mount kit has been discontinued?

 

[rubix_1011]

It's possible. You might try emailing them to see if you can still get one...might be worth it.

 

[expat]

It's possible. You might try emailing them to see if you can still get one...might be worth it.

hi rubix,
i took your advice and sourced some on aquatuning uk for an unbelievable 17.00 pounds sterling thats a d tek fuzion skt 1366 not just the mount kit.
thx again

 

[rubix_1011]

So you found what you are looking for...? I love my Dtek v2...although I'm using mine on on older Core 2 Quad...just curious to see what temps it holds on i7's since that might be my upgrade path at some point.

 

[expat]

So you found what you are looking for...? I love my Dtek v2...although I'm using mine on on older Core 2 Quad...just curious to see what temps it holds on i7's since that might be my upgrade path at some point.

temps at stock on mine bearing in mind i have 5870 xfire in my watercooling loop and also i live in spain where ambient temps are 28-36 degrees are as follows 33-36 degrees idle and 50 to 58 degrees load.