Search
Sign in with
Sign up | Sign in

CM690 Fans

Last response: in Overclocking
Share

hey guys, I just bought the following fans:
2x Slipstream 1600RPM,
1x S-Flex 1600,
1x S-Flex 1900,
1x GentleTyphoon 1850.
I have a mugen 2 cooler, CM690-1 stock fans.
I really need your advice on where to put each fan, and whether to replace them with the stock fans, and if so where to position the stock fans
(in other words, where would it be most important to put the better fans and where is it less important). Thanks!

More about : cm690 fans

Register or log in to remove

it depends, if you want negative pressure or positive pressure. I'm not sure how many fans you want to install. but two intake, two outtake would be good. intake usually front and side, while outtake back and top.

My own 690, has three intake, front, bottem, side. and two outtake back and top.

cheers

i have a 690 as well.. i have 3 intake, front, and 2 sides. 3 exhaust, rear and the 2 top

i have a fan controller the intakes run at 80% the exhaust at 100%. since the case is full of mesh, i know any extra air needed will be pulled through that. at least thats my theory. it works well.
Register or log in to remove
 
Ask the community
Read discussions in other Overclocking categories
!