Sign in with
Sign up | Sign in
Your question

Brand New P43-ES3G Post loop

Last response: in Motherboards
Share
January 13, 2010 3:23:26 PM

Just installed this MB. It post and i can get in to the bios screens. It sees all my gear ( HD, Mem ). But right after it posts the IRQ's it resets and posts again and again..

Any help would be great.

~D
January 13, 2010 3:51:04 PM

digimee said:
Just installed this MB. It post and i can get in to the bios screens. It sees all my gear ( HD, Mem ). But right after it posts the IRQ's it resets and posts again and again..

Any help would be great.

~D


Specs:

MB; P43-ES3G
mem corsair 667 2x1gig sticks
Pent d 3.0
PS: 500w
sata HD
nVidia gt9600

this stuff might help
also; I tried load Opt. defaults no luck just restarts over and over

~D
m
0
l
a c 435 V Motherboard
January 13, 2010 3:51:19 PM

You will have to format and reinstall windows. This is normal for vista and windows 7, and some older versions when you change the motherboard chipset.
m
0
l
Related resources
January 13, 2010 3:55:48 PM

It will not even boot off the CD-Rom

It just re-posts over and over. I would think it would do some thing else. like throw a windows error or can not boot error. but to just repost over and over..

Makes no sense..

~D
m
0
l
a c 177 V Motherboard
January 13, 2010 5:34:30 PM

Couple 'first guess' possibilities:
Have you done the (obligatory) "Load Optimized Defaults" from the BIOS? If not, do so...
What in the way of USB devices have you got plugged in? GB's have a well-known 'pickiness' about some USB stuff; I've never heard of either a ketboard or mouse causing this problem, but I've seen it with: external hard-drives, external CD/DVD writers, various brands of pen drives, and, I think I recall, someones brand of MP3 player... Reboot loops are the most common symptom. On theBIOS' "Integrated Peripherals" page, set "Legacy USB storage detect" (later BIOS say "USB Storage Function") - either way, set it to "Disabled"... If you still get looping with all USBs out, and that setting made, try this:
While it's in the loop, hold the power button depressed for long enough to get it to shut down completely. Turn off the power supply at the PSU swith, or unplug it. Do a CMOS reset, while it's off, or unplugged. Assuming you've gotten rid of the cause (no extraneous USBs, and the setting above corrected), you should be able to power up - do the 'Load Optimized' again, and you should be good to go...
m
0
l
January 13, 2010 6:20:59 PM

Thnaks Bilbat.. but still no good.
unplugged all usb's and ran through your steps but no good.
I even have it set to load from cd first and it will not load.

any other ideas? :D 

~D
m
0
l
!