M2N-SLI with Crucial Ballistix Memory

[dave_tiller]

I have a machine with the following hardware:

ASUS M2N-SLI motherboard
2x 1 GB Crucial Ballistix memory

It ran fine with XP Pro installed. I updated all firmware and loaded Windows 7 Enterprise. It started to blue screen with a 1A stop code for MEMORY_MANAGEMENT ever 2-3 days. Even when the machine is sitting idle. I've tested all hardware and it looks fine. I've ran the verifier and all drivers show up OK. I've seen some forums recommend changing the memory voltage and timings in the bios. My question is, what should they be set to? The crucial site says that the voltage should be 2.0 volts, but in the bios, it only goes to 1.95 volts for DDR2. Again, I have updated all firmware (including bios) and verified that all drivers are up to date.

Any suggestions on how to make this stable?

 

[dave_tiller]

I have a machine with the following hardware:

ASUS M2N-SLI motherboard
2x 1 GB Crucial Ballistix memory

It ran fine with XP Pro installed. I updated all firmware and loaded Windows 7 Enterprise. It started to blue screen with a 1A stop code for MEMORY_MANAGEMENT ever 2-3 days. Even when the machine is sitting idle. I've tested all hardware and it looks fine. I've ran the verifier and all drivers show up OK. I've seen some forums recommend changing the memory voltage and timings in the bios. My question is, what should they be set to? The crucial site says that the voltage should be 2.0 volts, but in the bios, it only goes to 1.95 volts for DDR2. Again, I have updated all firmware (including bios) and verified that all drivers are up to date.

Any suggestions on how to make this stable?

I also get the PFN_LIST_CURRUPT with stop code sometimes.