OCZ Fatal1ty OCZ550FTY 550W in a HP Pavilion a1600n

[daic]

Will a OCZ Fatal1ty OCZ550FTY 550W fit into a HP Pavilion a1600n?

 

[JohnnyLucky]

If that system has a standard atx tower case it will fit. If that is one of those narrow slimline cases it will not fit.

 

[daic]

Well will the connectors work? The actual size will fit, i was wondering about the connectors. My motherboard has a 24pin and the power supply has 20pin with a 4pin to make 24. The actual size of the connector is just a tiny bit smaller. Dont want to force the plug.

http://www.newegg.com/Product/Product.aspx?Item=N82E16817341022&nm_mc=AFC-Bleeping&cm_mmc=AFC-Bleeping-_-NA-_-NA-_-NA (PSU)

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00749157&jumpid=reg_R1002_USEN (Computer Spec)

 

[JohnnyLucky]

I just looked up the specs for your motherboard which is actually an ASUS A8M2N-LA model. For some unknown reason HP changed the model name to NodusM3-GL8E. It definitely has a standard 24 pin power connector and a standard 4 pin power connector on the motherboard. No problem.

The power supply also has standard power cables. Also no problem.

 

[daic]

Just wanted to make sure, i did try it out earlier but could not seem to fit. Ill have to move my HD out to get a better angle it seems.

To make sure, I can use the power supply with the pc correct? (assuming you looked at the two liked i gave for the PSU and the PC specs)

 

[sonic-boom]

Yes you can use that PSU with that PC. You put the 20 and the 4 pin next to each other, the arrow on the 4 pin should point TOWARDS the 20 pin connector, slide them both into the power port. The latch needs go on the side with the lip.