Hauppauge 1250 TV Tuner Installation Bios Problem

I put the card in, started up the computer, and got a long beeeep. No booting or video. I take the card out, the computer boots fine. What's going on here? is there a hardware conflict? The computer i am using is my home built one. Any suggestions are greatly appreciated
1 answer Last reply
More about hauppauge 1250 tuner installation bios problem
  1. Did you follow the instructions on how to install this card AND its Windows drivers? Maybe you have to Disable the on-board video chip and specify in BIOS that the boot video output device is the card newly installed in the PCIe bus.
Ask a new question

Read More

Tuner Cards TV Tuner Computer Hauppauge BIOS Graphics